Schmid Watson Specifications Page 57

  • Download
  • Add to my manuals
  • Print
  • Page
    / 103
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 56
W5-Ethernet-Manual.doc
Version 2.0-01
Watson 5 Ethernet
Operating Manual
Revision: 2006-04-27 7-3
Notes: ! In default configuration 0 the Ethernet interfaces 2, 3 and 4 are not configured to any VLAN and
cannot carry traffic
! In default configuration 1 the Ethernet interfaces 2 and 4 are not configured to any VLAN and
cannot carry traffic
DEFAULT (Tabletop)
For the Watson 5 Ethernet tabletop modems the DEFAULT values are as follows:
Parameter
DEFAULT 0 DEFAULT 1 DEFAULT 2
SHDSL
Autorestart Enabled Enabled Enabled
Power Backoff Disabled Disabled Disabled
Linerate 2048 kbit/s 2304 kbit/s 4608 kbit/s
Operating Mode 1 Pair 1 Pair 2 Pairs
DSL Sync rate 2056 kbit/s 2312 kbit/s 2312 kbit/s
Ethernet
Interface mode Auto Auto Auto
Flow control Auto Auto Auto
Bridge filtering Enable Enable Enable
Clock mode Remote Remote Remote
Bitrate 2048 kbit/s 2304 kbit/s 4608 kbit/s
HDLC tagging Off Off Off
Table 7-3: DEFAULT values for Watson 5 Ethernet tabletop
Notes ! The default configurations in Table 7-3 are given for DSL master mode. If the modem is in DSL
slave mode then the DSL linerate is determined by the DSL master and not by the DEFAULT
command.
! The factory setting can be loaded using the DEFAULT 2 command. All DSL plugins and table-
tops are delivered with this configuration (plugins as DSL master, tabletops as DSL slave).
! The Master/Slave and Remote Powering settings are not affected by the DEFAULT command
Page view 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 102 103

Comments to this Manuals

No comments