Schmid Watson Specifications Page 76
- Page / 103
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Watson 5 Ethernet
Operating Manual
W5-Ethernet-Manual.doc
Version 2.0-01
7-22 Revision: 2006-04-27
7.2.5 Test loops
LOOP1 Ethernet-Port ON timeout | OFF
The LOOP1 command controls the local loopback, cf. chapter 3.6:
The loop is automatically cleared after the timeout specified in the command (5 minutes in the ex-
ample above). If no timeout value is specified then the loop will stay active until it is deactivated by
a LOOP1 OFF command.
LOOP2 DSL-Port ON timeout | OFF
The LOOP2 controls starts the remote loopback on a DSL port.
The loop is automatically cleared after the timeout specified in the command (5 minutes in the ex-
ample above). If no timeout value is specified then the loop will stay active until it is deactivated by
a LOOP2 OFF command.
Monitor LOOP2 commands. In case of remote Loop 2 requests, the master has higher priority that
the slave.
Notes: ! On the Watson 5 Ethernet tabletop modems it is not possible to specify an Ethernet or a DSL
port.. LOOP1 loops the Ethernet port, LOOP2 the remote DSL port.
! On the Watson 5 Ethernet tabletop modems a loop timeout is not supported
! The LOOP2 command is not available on the Watson 5 Ethernet tabletop modem if it is con-
figured as DSL slave
! Looped-back Ethernet packets egress the modems from the same port they were sent to and
have the same source and destination addresses they were sent with. While Ethernet testing
equipment can handle this situation it might be very confusing for "normal" Ethernet ports or
Ethernet switches.
7.2.6 Reset Commands
RESET
Typing RESET on the Watson 5 Ethernet tabletop resets the modem.
RESET DSL-Port
Typing RESET DSL-Port on the Watson 5 Ethernet plugin restarts a DSL link:
RESETCARD
The RESETCARD command initiates a complete hardware and software reset of the Watson 5
Ethernet plugin. The RESETCARD command must be confirmed before it is processed.
Note: This command is not available on the Watson 5 Ethernet tabletop modem.
- Declaration of Conformity 3
- Revision: 2006-04-27 5
- Limited Product Warranty 7
- Table of Contents 9
- Watson 5 Ethernet 11
- Operating Manual 11
- Revision: 2006-04-27 xi 11
- W5-Ethernet-Manual.doc 11
- Version 2.0-01 11
- Revision: 2006-04-27 xiii 13
- 1 Related Documents 15
- 2 Overview 17
- Figure 2-2: Campus Networks 18
- 2.3 Modem Types 19
- 2.4 Accessories 19
- 2-4 Revision: 2006-04-27 20
- 3 Modem Features 21
- 3.1.2 Multipair operation 22
- 3.1.3 Power Backoff 23
- 3.1.5 DSL Performance 23
- 3.1.6 Wetting Current 24
- 3.1.7 Master / Slave 25
- 3.1.8 DSL Clocking 25
- 3.2 Ethernet (plugin modem) 26
- 3.2.3 VLANs 27
- 3.2.4 VLAN Examples 28
- Revision: 2006-04-27 3-13 29
- 3-14 Revision: 2006-04-27 30
- 3.2.6 Stacked VLANs 31
- 3-16 Revision: 2006-04-27 32
- 3.3.1 Ethernet over DSL 33
- 3.3.2 VLAN transparency 33
- 3.3.3 Mixed mode operation 34
- 3.3.4 Cisco HDLC 34
- 3.4 Firmware update 35
- 3.5 Management 35
- 3-20 Revision: 2006-04-27 36
- Revision: 2006-04-27 3-21 37
- Tabletop 38
- Revision: 2006-04-27 3-23 39
- 3.7 Test loops 40
- 3.8 Password protection 40
- Revision: 2006-04-27 3-25 41
- 4 Powering 43
- 5 LEDs and Alarms 45
- 5.2 Tabletop LEDs 46
- 5.3 Alarm Conditions 47
- 5.4 Alarm Relays 47
- 5.5 Initialization Errors 48
- 6 The Monitor 49
- 6.2 Addressing of Plugins 50
- 6.3 Naming of ports 51
- 6.4 Telnet Access 51
- 6.5.1 Welcome Screen 52
- 6.5.2 Menus 52
- 6.5.3 Prefixes an Shortcuts 52
- 6.5.4 Tab completion 53
- 6.5.5 Help 53
- 6.5.6 Command History 53
- 6.5.7 Continuous Displays 53
- 7.1.1 General Commands 55
- 7-2 Revision: 2006-04-27 56
- Revision: 2006-04-27 7-3 57
- 7-4 Revision: 2006-04-27 58
- Revision: 2006-04-27 7-5 59
- 7-6 Revision: 2006-04-27 60
- Revision: 2006-04-27 7-7 61
- 7-8 Revision: 2006-04-27 62
- 7.1.7 VLAN Configuration 63
- 7-10 Revision: 2006-04-27 64
- Revision: 2006-04-27 7-11 65
- 7-12 Revision: 2006-04-27 66
- Revision: 2006-04-27 7-13 67
- 7-14 Revision: 2006-04-27 68
- Revision: 2006-04-27 7-15 69
- 7-16 Revision: 2006-04-27 70
- 7.2.1 Diagnostic 71
- 7.2.2 Status (Plugin) 72
- 7.2.3 Status (Tabletop) 73
- 7.2.4 Alarms 74
- Revision: 2006-04-27 7-21 75
- 7.2.5 Test loops 76
- 7.2.6 Reset Commands 76
- 7.3.1 G.826 Statistics 77
- 7.3.2 Ethernet Statistics 78
- Revision: 2006-04-27 7-25 79
- 7.4.1 Connection control 80
- 7.4.2 Inventory 80
- 7.4.3 Password 81
- 7.4.4 Firmware Upgrade 82
- Revision: 2006-04-27 7-29 83
- 8 SNMP 85
- 8.1.3 The Entity MIB 86
- 8.1.2 SNMP Configuration 86
- 8.1.4 VLAN indexing 87
- 8.2 MIB Reference 88
- 8.2.5 Entity MIB (RFC 2737) 89
- 8.2.6 RMON (RFC 2819) 89
- 8.2.7 IF MIB (RFC 2863) 89
- 8.2.11 MAU MIB (RFC 3636) 90
- 8.2.13 HDSL MIB 91
- 8.2.14 Schmid MIB 91
- 8.2.15 Watson MIB 91
- 9 Front and Rear Panels 93
- 10 Connectors and Cables 95
- 10.1.2 DSL Cable 96
- 10.2 Ethernet Interface 97
- 10.3 Monitor Interface 97
- 10.4 Power and Grounding 98
- 11.1 Interfaces 99
- 11.2 Power Consumption 100
- 11.3 Ethernet 100
- 11.4 Latency and Throughput 101
- 11.5 Management Functions 101
- 11.6 MTBF 101
- 11.7 Environment 102
- 12 Terminology 103
Related products and manuals for Networking Schmid Watson
Networking Schmid Watson Installation Guide
(129 pages)
(129 pages)
Networking Schmid Watson Specifications
(130 pages)
(130 pages)
© 2020, manymanuals.com. All rights reserved. | 0.075 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals