Schmid Watson Specifications download pdf (Page 49)

Revision: 2006-04-27

6-1

6 The Monitor

6.1 Introduction

For configuration and diagnostics the modems have a serial interface to connect a terminal or a PC

with terminal emulation. The serial interface is available on the backplane of the tabletops, on the

ACU, the minirack mechanics and the plugin tabletop housing.

A modem configured as DSL slave is also accessible from the master side through the DSL EOC.

The Monitor terminal or terminal emulation must be VT100 compatible and must be configured as

follows:

! 9600 baud, asynchronous

! 8 bits, no parity, one stop bit

! No new line on carriage return (i.e. no line feed on carriage return)

! XON/XOFF enabled

Notes: ! Between plugin and the terminal the XON/XOFF protocol is used for flow control. In order to

re-enable communication with an plugin occasionally left in XOFF state, it is recommended to

start each session with Ctrl-Q (=XON) followed by an ECHO command.

! If you use the HyperTerm terminal emulator delivered with Windows® then you must configure

HyperTerm for VT100 emulation in the "Settings" tab of the connection properties (File –

Properties).

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 102 103

No comments

Schmid Watson Specifications Page 49