Schmid Watson Specifications download pdf (Page 81)

W5-Ethernet-Manual.doc

Version 2.0-01

Watson 5 Ethernet

Operating Manual

Revision: 2006-04-27 7-27

7.4.3 Password

CHANGE PASSWORD

The CHANGE PASSWORD command is used to change a password. The old password has to be

known to change it. The new password must be entered twice to confirm it.

NTU_SM> CHANGE PASSWORD

Old password: ******

New password: ******

Confirm new password: ******

52:11:40 new password set

CLEAR PASSWORD

The CLEAR PASSWORD command clears the currently set password and disables password

protection. This is the factory default setting.

NTU_SM> CLEAR PASSWORD

Old password: ******

Password cleared and Monitor protection disabled

DSLSLAVE

The DSLSLAVE command is the only command allowed while password protection is active. The

DSLSLAVE command is used to configure a master tabletop as a DSL slave to allow a remote

terminal access in case the password of a master tabletop has to be changed or cleared.

Monitor Password Protection

Enter password: ******** (typed DSLSLAVE)

Device is now DSL slave

Note: Through the remote terminal, i.e. through the DSL EOC the password commands are available with-

out password protection. If a modem has been password protected and the password has been lost

then it can be cleared again from modem configured as DSL master. If the modem who's password

has been lost is configured as DSL master it can be set to DSL slave with the DSLSLAVE command

that is available even while password protection is active.

LOGOFF

LOGOFF activates the password protected mode. The previously set password has to be entered

before any new Monitor commands can be issued via the local terminal.

SET PASSWORD

The SET PASSWORD command allows definition of a password on the tabletop. Once a pass-

word is set the modem will go into a protected mode either after the command LOGOFF is issued,

after a timeout of 5 minutes or after a restart.

While in protected mode no Monitor command can be executed from a terminal connected to the

local RS-232 port of the modem before the correct password has been given. All commands are still

available on the remote terminal, i.e. through the DSL EOC. This allows somebody with access to

an unprotected modem to reset the password of a protected modem.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 102 103

Comments to this Manuals

No comments

Schmid Watson Specifications Page 81

Comments to this Manuals

Related products and manuals for Networking Schmid Watson